2. 计算机
  3. You are the network administrator for Ezonexam.com. You need to upgrade a computer from Windows NT Server 4.0 to Windows 2000 s

You are the network administrator for Ezonexam.com. You need to upgrade a computer from Windows NT Server 4.0 to Windows 2000 s

admin2009-05-19  16
问题 You are the network administrator for Ezonexam.com.

You need to upgrade a computer from Windows NT Server 4.0 to Windows 2000 server. The server has dual processors, 2 GB of RAM, a RAID controller with five SCSI hard disks in an array, and a generic 10/100-MB network adapter. You begin the installation of the Windows 2000 Server operating system.

During the text portion of the installation, you receive the following error message:
"Stop 0x00000078 Inaccessible_boot_device."

You want to successfully upgrade the computer.

What should you do? (Each answer presents part of the solution. Choose two)
选项 A、Start the computer by using a DOS disk and run FDISK.
B、Update the firmware on the RAID controller.
C、Restart the installation. During the text-mode setup-mode setup, press F6.
D、Restart the installation. During the text-mode setup, create a new partition.
E、Insert a floppy disk containing the OEM SCSI driver and specify the additional driver.
答案C,E
解析 Explanation: As soon as your machine boots into the text-based portion of Setup, you may notice a prompt at the bottom of the screen that tells you to press F6 if you need to install additional SCSI or RAID drivers. If you don’t want these additional drivers, just wait a few seconds and it will go away. But if your system has a SCSI or RAID controller that you know isn’t going to initialize without an OEM-provided driver, you’ll need to watch this part of Setup closely and hit F6. You’ll need to press F6 at the Press F6 prompt to install SCSI drivers. This will let you access your SCSI hard drives or CD-ROMs that require a driver.

Incorrect answers:
A: This is similar to creating a partition. There is no need to create a new partition. This will not upgrade the computer successfully.

B: This is not required. Updating firmware on the RAID controller will not enable you to successfully upgrade the computer in this case.

D: There is no need to create a new partition, you should press F6 which will allow you to successfully upgrade the computer by allowing access to the hard drives or floppy or CD-ROM drives that requires drivers.
转载请注明原文地址:https://jikaoti.com/ti/tVO7FFFM
本试题收录于： 微软70215题库微软认证分类
0

微软70215

微软认证

相关试题推荐
随机试题
最新回复(0)